15
5 Connecting to power supply
PLICSMOBILE T61 • External GSM/GPRS radio unit
37700-EN-130228
Fig. 5: Connection steps 4 and 5
5. Insert the wire ends into the terminals according to the wiring plan
Information:
Solidcoresaswellasexiblecoreswithcableendsleevesare
inserteddirectlyintotheterminalopenings.Incaseofexiblecores
without end sleeves, press the terminal head with a small screwdriver;
the terminal opening is freed. When the screwdriver is released, the
terminal closes again.
6. Check the hold of the wires in the terminals by lightly pulling on
them
7. Connect the screen to the internal ground terminal, connect the
outer ground terminal to potential equalisation
8. Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
9. Screw the housing cover back on
Theelectricalconnectionishencenished.
Information:
The terminal block is pluggable and can be removed from the elec-
tronics. To do this, lift the terminal block with a small screwdriver and
pull it out. When inserting the terminal block again, you should hear it
snap in.
Comments to this Manuals