Vega WHA-GW-WIRELESSHART GATEWAY User Manual download pdf (Page 56)

WHA-GW-*

Configuration

221981 2011-07

Network Explorer – Burst Messages

5.5 Wired Communication Parameters

5.5.1 Interfaces > Serial

The Gateway can connect to the host system via an Ethernet interface or a Serial interface.

The parameters concerning the Serial interface can be found here. The parameters for the

Ethernet interface are described in the following section.

Figure 5.5Parameter > Wired Communication > Interfaces > Serial

NExplorer

Contents

Description

Burst Command Displays the HART command number.

Number of

packets

Number of burst messages the selected device has sent.

Table 5.6Network Explorer – Burst Messages

Note!

If you are connected to the Gateway using the HART IP communication DTM (Ethernet),

make sure to update the parameters of the HART IP communication DTM (see chapter

4.6.2) when changing the following Gateway parameters:

- Parameterization > Wired Communication > Interfaces > Ethernet > IP Address

- Parameterization > Wired Communication > Protocols > HART > Bus Address

- Parameterization > Wired Communication > Protocols > HART > Port Number.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 95 96

No comments

Vega WHA-GW-WIRELESSHART GATEWAY User Manual Page 56